Is aluminum an MC cable?

June 23, 2020 Off By idswater

Is aluminum an MC cable?

MC wires conductor is an 8000 series aluminum conductor. These conductors are also light, soft, and flexible, hence easy to work with, especially during installation.

What is Mc Al wire?

A Metal Clad Cable, also referred to as MC Cable, is a corrosion-resistant metal cable containing insulated copper or aluminum connectors.

Is MC cable aluminum or steel?

MC-Stat® Cable (Steel and Aluminum) Hospital grade with two ground fault paths that meet NEC 517 requirements for health care applications.

What is MC wire used for?

Type MC cables are widely used in 600 volt and MV power, lighting and fixture whip control applications. They are permitted for use on services, feeders and branch circuits for power, lighting, control and signaling circuits in accordance with Article 330 and 725 of the NEC.

Can you run MC in conduit?

Type MC armored cable can be installed in cable tray, racks, hangers, or as a cost-effective replacement for conduit and wire where specified per the National Electrical Code (NEC).

Can MC wire be exposed?

These cables can be installed either indoors or outdoors and in exposed and concealed locations. They can be direct buried, where identified for such use. Type MC cable with a nonmetallic jacket can also be used in a wet location.

Is MC wire waterproof?

A: The metal MC cable corrugations must always be impervious to moisture. B: The insulated conductors under the metallic covering must be listed for damp locations.

Can MC cable get wet?

PVC coated, sunlight resistant, direct burial rated MC cable can be used in a wet location. General use MC cables cannot be used in wet locations but there are some types of specialty MC cables that can. The most common is the PVC coated, sunlight resistant, direct burial listed MC cable in the image.

Can you run MC cable exposed?

Section 330.15 states: Exposed runs of cable, except as provided in 300.11(A), shall closely follow the surface of the building finish or running boards. Exposed runs shall also be permitted to be installed on the underside of joists where supported at each joist and located so as not to be subject to physical damage.