What protocol does turnigy use?

March 13, 2020 Off By idswater

What protocol does turnigy use?

Re: 9X mode The standard module uses a protocol known as FlySky V2. They probably have a fancy marketing name for it but so far HobbyKing simply refer it as the V2 (version 2) protocol.

Are turnigy transmitters good?

The Turnigy 9X is one of the best RC transmitters out there at the moment for it’s price. For $60, you’ll get a 9 channel transmitter (8 usable), a receiver and a bind plug, but with no battery. I have been using this transmitter for over 3 months now, so I decided to share some of my opinions about this product.

What is Afhds 2A protocol?

The AFHDS-2A protocol is used to control Turnigy/Flysky AFHDS 2A receivers. NOTE: This protocol requires the addition of an ‘A7105’ hardware module to function.

Where does the bind plug go?

To Bind the Micro Receiver: With the transmitter and receiver power off, insert the bind plug into the battery/bind port on the receiver labeled B. Power up the receiver by turning on the electronic speed control (electric cars) or turn on the battery switch (gas car).

How do you bind a turnigy 9x battery?

1. Plug bind plug into battery socket in receiver. 2. Plug battery to any slot. Red LED blinks ready to bind. 3. Push and hold bind button on TX while switching it on. 4. Hold until red LED on receiver stops blinking. Takes one or two seconds.

How to bind flysky / turnigy 9x RC groups?

9X is an advanced and complex computer radio. If you don’t know how to set up this radio, you can’t use it even after it is bound. 1. Plug bind plug into battery socket in receiver. 2. Plug battery to any slot. Red LED blinks ready to bind. 3. Push and hold bind button on TX while switching it on.

What to do with turnigy 9X in two way mode?

If you are using a non-telemetry receiver (V8) you need to have switch 1 off and switch2 on for binding. After that, turn both transmitter and receiver off and restart, after that it should work nicely. If you are using a telemetry receiver (D8 or two way mode) then you need to turn both switches off for binding and normal operation.

Where is the antenna wire on a turnigy 9x transmitter?

Once you have taken the screws off the stock module, you will find the antenna wire is soldered on the PCB with 2 joints. De-solder these joints to remove cable from the board so the module can be removed from the transmitter body. Note that on the latest 9x transmitters, there is a plastic lip around the connection pins.